Users Manual

SGW101X Series
@2019 | SG Wireless Limited
Confidential Proprietary
Website : www.sgwireless.com
15
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence.
L'exploitation est autorisée aux deux conditions suivantes : (1) l'appareil ne doit pas produire de brouillage, et (2)
l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d'en
compromettre le fonctionnement.
RF exposure warning:
This equipment complies with IC radiation exposure limits set forth for an uncontrolled environment. This equipment
should be installed and operated with minimum distance of 20 cm between the radiator and your body. This transmitter
must not be co-located or operating in conjunction with any other antenna or transmitter.
Avertissement d'exposition Cet équipement est conforme aux limites d’exposition aux rayonnements de la IC établies
pour unenvironnement non contrôé. Cet équipement doit être installé et fonctionner à au moins 20cm de distance d’un
radiateur ou de votre corps.
OEM Responsibilities to comply with IC Regulations
The SGW101X series have been certified for integration into products only by OEM integrators under the following
conditions:
o
The antenna(s) must be installed such that a minimum separation distance as stated above is maintained between
the radiator (antenna) and all persons at all times.
o
The transmitter module must not be co-located or operating in conjunction with any other antenna or transmitter.
As long as the two conditions above are met, further transmitter testing will not be required. However, the OEM
integrator is still responsible for testing their end-product for any additional compliance requirements required with this
module installed (for example, digital device emissions, PC peripheral requirements, etc.).
Important Note:
In the event that these conditions cannot be met (for certain configurations or co-location with another transmitter),
then the ISEDC authorization is no longer considered valid and the IC ID cannot be used on the final product. In these
circumstances, the OEM integrator will be responsible for re-evaluating the end product (including the transmitter) and
obtaining a separate ISEDC authorization.
End Product Labeling
The SGW101X series are labeled with its own IC ID. If the IC ID is not visible when the module is installed inside another
device, then the outside of the device into which the module is installed must also display a label referring to the
enclosed module. In that case, the final end product must be labeled in a visible area with the following:
“Contains IC: 25021-01”
The OEM integrator has to be aware not to provide information to the end user regarding how to install or remove this
RF module or change RF related parameters in the user manual of the end product.