Technical information
Table Of Contents
- GoMobile Cover
- SGC – The SSB People
- Go Mobile at 500 Watts
- T a b l e o f C o n t e n t s
- I n t r o d u c t i o n
- C h a p t e r 1 C h a n g e s i n M o b i l e R a d i o
- C h a p t e r 2 O r i e n t i n g Y o u r s e l f t o 5 0 0 W a t t s
- C h a p t e r 3 DCP o w e r S u p p l y S y s t e m f o r a M o b i l e I n s t a l l a t i o n
- C h a p t e r 4 A n t e n n a s a n d G r o u n d s
- C h a p t e r 5 N o i s e S u p p r e s s i o n a n d S h o c k -M o u n t i n g
- C h a p t e r 6 I n s t a l l a t i o n P r o c e d u r e s
- C h a p t e r 7 I n s t a l l a t i o n V a r i a b l e s
- C h a p t e r 8 G o i n g M o b i l e a t 1 5 0 W a t t s
- Appendix A — QMS S y s t e m
- A p p e n d i x B — S e l e c t i o n o f E q u i p m e n t
- A p p e n d i x C — T e s t D a t a
- It all Adds Up
• Efficient, all-band, high-power performance using a
proven antenna design with both electrical and mechani-
cal integrity under the most adverse driving conditions.
• Easy transportability from one vehicle to the next. The
QMS mounting system can be considered “semi-perma-
nent” because its suction cups and strapping allow
removing the entire unit from one vehicle for immediate
installation on another. The QMS goes in place, and stays
in place, until you need to move it.
• Non-intrusive mounting design. The QMS system allows
you to enjoy mobile operation without depreciating your
vehicle’s value with unsightly holes, with scrapes and
scuffs from magnetic or other mounting techniques.
Drilling body panel holes in a $20,000 vehicle to accom-
modate a $20 fitting is not something even the most avid
mobile operator would accept.
Mounting ledges for QMS straps and hooks. Suction
cups form one half of the QMS anchoring system; nylon
straps finish the job. Included with your QMS system are
several plastic-coated steel hooks. The nylon straps loop
through these, and the hooks hold onto ledges to form a
secure anchor point from which to tighten the strap tension.
On most compact vehicles (especially ones with hatchbacks),
mount the QMS unit on the left rear side window. Each of
four straps will tie to the front door frame, to the hatchback,
to the wheel well (fender), and either to the roof or to the
lower body edge.
For this installation, find body panel edges or “lips” on which
the steel hooks will catch and anchor. With a little bit of
exploration and ingenuity on your part, you can find the
edges needed to secure the hooks and mounting straps.
7
© 1997 SGC Inc.
SGC Inc. SGC Building, 13737 S.E. 26th St. Bellevue, WA. 98005 USA
P.O.Box 3526, 98009 Fax: 425-746-6384 or 746-7173 Tel: 425- 746-6310 or 1-800-259 7331
E-mail: SGCMKTG@aol.com Website: http://www.sgcworld.com