Technical information
Table Of Contents
- GoMobile Cover
- SGC – The SSB People
- Go Mobile at 500 Watts
- T a b l e o f C o n t e n t s
- I n t r o d u c t i o n
- C h a p t e r 1 C h a n g e s i n M o b i l e R a d i o
- C h a p t e r 2 O r i e n t i n g Y o u r s e l f t o 5 0 0 W a t t s
- C h a p t e r 3 DCP o w e r S u p p l y S y s t e m f o r a M o b i l e I n s t a l l a t i o n
- C h a p t e r 4 A n t e n n a s a n d G r o u n d s
- C h a p t e r 5 N o i s e S u p p r e s s i o n a n d S h o c k -M o u n t i n g
- C h a p t e r 6 I n s t a l l a t i o n P r o c e d u r e s
- C h a p t e r 7 I n s t a l l a t i o n V a r i a b l e s
- C h a p t e r 8 G o i n g M o b i l e a t 1 5 0 W a t t s
- Appendix A — QMS S y s t e m
- A p p e n d i x B — S e l e c t i o n o f E q u i p m e n t
- A p p e n d i x C — T e s t D a t a
- It all Adds Up
something wrong. Stop. Examine the fastener more closely to
see if it has a center shaft that must be pulled first before
removing the remainder of the fastener.
With the moldings removed, you should be able to unclip the
edges of the carpeting to expose a small length of the vehicle
floor.
Running the cable. Route the cable beneath the carpeting,
along the right side of the vehicle floor, all the way to the
rear deck or trunk compartment.
Figure 9 — Peel back
the carpet in a
Cadillac to permit a
cable run
Next run the control cables. Then clip the carpet in place
again and reinstall the moldings.
Seat Belt Anchor Bolts: In some vehicles, you may find
that the large bolts used to anchor the seat belt
restraint/feed mechanism may block the routing of cables
along the door moldings. Whenever possible, bypass these
bolts rather than attempting to remove them to facilitate
cable feed through.
• Seat belt anchor bolts are specially designed and
installed on the assembly line using high torque. They
usually have a liquid locking compound applied to their
32
SGC Inc. SGC Building, 13737 S.E. 26th St. Bellevue, WA. 98005 USA
P.O.Box 3526, 98009 Fax: 425-746-6384 or 746-7173 Tel: 425- 746-6310 or 1-800-259 7331
E-mail: SGCMKTG@aol.com Website: http://www.sgcworld.com
© 1997 SGC Inc.