Technical information
Table Of Contents
- GoMobile Cover
- SGC – The SSB People
- Go Mobile at 500 Watts
- T a b l e o f C o n t e n t s
- I n t r o d u c t i o n
- C h a p t e r 1 C h a n g e s i n M o b i l e R a d i o
- C h a p t e r 2 O r i e n t i n g Y o u r s e l f t o 5 0 0 W a t t s
- C h a p t e r 3 DCP o w e r S u p p l y S y s t e m f o r a M o b i l e I n s t a l l a t i o n
- C h a p t e r 4 A n t e n n a s a n d G r o u n d s
- C h a p t e r 5 N o i s e S u p p r e s s i o n a n d S h o c k -M o u n t i n g
- C h a p t e r 6 I n s t a l l a t i o n P r o c e d u r e s
- C h a p t e r 7 I n s t a l l a t i o n V a r i a b l e s
- C h a p t e r 8 G o i n g M o b i l e a t 1 5 0 W a t t s
- Appendix A — QMS S y s t e m
- A p p e n d i x B — S e l e c t i o n o f E q u i p m e n t
- A p p e n d i x C — T e s t D a t a
- It all Adds Up
by an adjustable mounting arm between the base and the
control head (or speaker).
To mount the remote kit, first prepare the windshield surface
by wiping it off with glass cleaner. Next loosely assemble the
control head to the adjustable mounting arm and lift and
position the entire assembly against the windshield. Shift the
mount around to determine how high on the windshield the
mount should be placed to allow ample room to position the
control head for the desired angle. You can mark the position
on the windshield with some strips of masking tape or with a
stroke from a thin piece of bar soap (which will wipe off eas-
ily, unlike permanent markers!). Remove the mount and
detach the control head from the adjustable mounting arm.
Figure 11— Seen from outside the GEO Metro, the
suction cup mounting securely holds the PowerTalk
remote head
For better adhesion and sealing, apply a thin coat of Vaseline
to the suction cups before pressing them into place (use suf-
ficient force to evacuate all the air from within the cups).
The mounting arm can be adjusted through several axes by
loosening and tightening both the hexagonal screws and the
wing-knobs. A slight “droop” will occur between the position
of a unloaded and loaded arm (that is, with the control head
35
© 1997 SGC Inc.
SGC Inc. SGC Building, 13737 S.E. 26th St. Bellevue, WA. 98005 USA
P.O.Box 3526, 98009 Fax: 425-746-6384 or 746-7173 Tel: 425- 746-6310 or 1-800-259 7331
E-mail: SGCMKTG@aol.com Website: http://www.sgcworld.com