Technical information
Table Of Contents
- GoMobile Cover
- SGC – The SSB People
- Go Mobile at 500 Watts
- T a b l e o f C o n t e n t s
- I n t r o d u c t i o n
- C h a p t e r 1 C h a n g e s i n M o b i l e R a d i o
- C h a p t e r 2 O r i e n t i n g Y o u r s e l f t o 5 0 0 W a t t s
- C h a p t e r 3 DCP o w e r S u p p l y S y s t e m f o r a M o b i l e I n s t a l l a t i o n
- C h a p t e r 4 A n t e n n a s a n d G r o u n d s
- C h a p t e r 5 N o i s e S u p p r e s s i o n a n d S h o c k -M o u n t i n g
- C h a p t e r 6 I n s t a l l a t i o n P r o c e d u r e s
- C h a p t e r 7 I n s t a l l a t i o n V a r i a b l e s
- C h a p t e r 8 G o i n g M o b i l e a t 1 5 0 W a t t s
- Appendix A — QMS S y s t e m
- A p p e n d i x B — S e l e c t i o n o f E q u i p m e n t
- A p p e n d i x C — T e s t D a t a
- It all Adds Up
cle with sufficient length to easily reach the Powercube
amplifier.
Trim excess lead at the amplifier: When installing the
remote control box, excess lead length will be trimmed at the
box, rather than at the amplifier. This is because the small 4-
pin plug used for on/off and LED power is pre-assembled at
the factory and should not be cut off and re-wired.
Referring to the instructions provided with the remote con-
trol box, connect the six-wire (input filter select) plug to its
mating connector on the Powercube, and the small four-wire
plug into the pin jumper located next to the PTT/Filter
Select switches.
The wires at other end of the cable will be attached to the
connector on the remote control box.
Exterior
Unique to the QMS antenna/coupler configuration is its
mounting strap system. No other manufacturer presently
offers a system utilizing this approach. The QMS system
addresses three important aspects of mobile operations:
• Truly efficient, all-band, high-power performance
using a proven antenna design with both electri-
cal and mechanical integrity under the most
adverse driving conditions.
• Easy transportability from one vehicle to another.
The QMS mounting system is “semi-permanent”
because its suction cup and strapping allow ready
removal of the entire unit. The QMS goes in place,
and stays in place, until you need to move it.
• Non-intrusive mounting design. No drilling body
panel holes in a $10,000 to $20,000 vehicle to
accommodate a $20 fitting, the QMS system
allows you to enjoy mobile operation without
38
SGC Inc. SGC Building, 13737 S.E. 26th St. Bellevue, WA. 98005 USA
P.O.Box 3526, 98009 Fax: 425-746-6384 or 746-7173 Tel: 425- 746-6310 or 1-800-259 7331
E-mail: SGCMKTG@aol.com Website: http://www.sgcworld.com
© 1997 SGC Inc.