Technical information
Table Of Contents
- GoMobile Cover
- SGC – The SSB People
- Go Mobile at 500 Watts
- T a b l e o f C o n t e n t s
- I n t r o d u c t i o n
- C h a p t e r 1 C h a n g e s i n M o b i l e R a d i o
- C h a p t e r 2 O r i e n t i n g Y o u r s e l f t o 5 0 0 W a t t s
- C h a p t e r 3 DCP o w e r S u p p l y S y s t e m f o r a M o b i l e I n s t a l l a t i o n
- C h a p t e r 4 A n t e n n a s a n d G r o u n d s
- C h a p t e r 5 N o i s e S u p p r e s s i o n a n d S h o c k -M o u n t i n g
- C h a p t e r 6 I n s t a l l a t i o n P r o c e d u r e s
- C h a p t e r 7 I n s t a l l a t i o n V a r i a b l e s
- C h a p t e r 8 G o i n g M o b i l e a t 1 5 0 W a t t s
- Appendix A — QMS S y s t e m
- A p p e n d i x B — S e l e c t i o n o f E q u i p m e n t
- A p p e n d i x C — T e s t D a t a
- It all Adds Up
Nylon wire ties wrapped around the straps keep them from
“fluttering” at high speeds and neatly bundle the coupler
cable and braided ground strap along with the tie-downs.
Clip off excess tie. (See Appendix A for additional informa-
tion on the QMS installation.)
Mounting the SG-303 antenna. The antenna which
screws into the QMS ratchet mount is not a temporary instal-
lation.
Assembling the antenna: To assemble the SG-303 antenna,
use wrenches to tighten the two sections together.
Figure 15 —
Tighten the two
sections of the
whip with wrench-
es
Installing the antenna:
Installing the SG-303 antenna
requires two people: one to hold the rubber boot and the
other to tighten the antenna into the ratchet mount, using a
wrench.
50
SGC Inc. SGC Building, 13737 S.E. 26th St. Bellevue, WA. 98005 USA
P.O.Box 3526, 98009 Fax: 425-746-6384 or 746-7173 Tel: 425- 746-6310 or 1-800-259 7331
E-mail: SGCMKTG@aol.com Website: http://www.sgcworld.com
© 1997 SGC Inc.
Caution: A hand-tightened antenna will permit
movement which can break the antenna ferrules.
If the whip is too loose, you can feel it flap when
it passes its vertical point.