User manual

Mailing: PO Box 3526, Bellevue, WA. 98009
Shipping: 13737 SE 26
th
St. Bellevue, WA. 98005
Toll Free: 800-259-7331 * Phone: [phone] * Fax: [phone]
www.sgcworld.com * Email: [e-mail]
65
This LED shows the status of the antenna impedance. When lit, the
impedance is 50 ohms or less. When off, the impedance is greater
than 50 ohms.
2:1
This LED will light when the VSWR is greater than 2:1. It will
extinguish when VSWR is less than 2:1.
PHZ
This LED indicates the status of the antenna reactance. When lit,
reactance is inductive. When off, reactance is capacitive.
FWD
This LED indicates the presence or lack of RF power from the
radio. When transmitting, the LED will light to indicate RF is
being detected. In receive, the LED should be extinguished.
OTHER
All LEDs will blink on and off at a rate of 2Hz to indicate the tuner
was not able to find a valid match.
Note that these status LEDs are usually used to aid a technician in
diagnosing the status of the antenna system and should not be
thought of as laboratory instruments.
Mailing: PO Box 3526, Bellevue, WA. 98009
Shipping: 13737 SE 26
th
St. Bellevue, WA. 98005
Toll Free: 800-259-7331 * Phone: [phone] * Fax: [phone]
www.sgcworld.com * Email: [e-mail]
66
As the Smartuner tunes, the BITE status will be continually
updated from the CPU.