User`s manual

SG-211 User’s Manual

5. Key the PTT switch on the microphone and

talk into the microphone. Notice that the

light turns on when you talk.

COUPLER TEST PROCEDURE

1. Connect the coupler to the radio.

2. Connect coupler light bulb load to Smartuner coupler

antenna out-put.

3. Turn on the radio and the Smartuner coupler.

4. Set the radio to the CW mode.

5. Key the PTT switch on the microphone and look at

the light bulb. The light should turn on if the coupler

has completed its’ tuning cycle and if the radio is

transmitting.

6. For further testing, follow steps 4 & 5 of the radio

test procedure. Note: The light bulb might not turn on

immediately if the coupler has not yet been tuned for

the frequency of the transmitter. The output power

(light-bulb brightness) is greatest when the coupler is

properly tuned. This test will ensure that the radio

and coupler are working properly.