User`s guide

42 007-4834-001
3: Operating Storage Enclosures
4. Disengage the air filter (callout 3 in Figure 3-8) from the screen frame’s retaining
clips (callout 2).
Figure 3-8 Remove or Replace an Air Filter in the Bezel’s Screen Frame
5. Insert the new air filter (or clean filter) into the screen frame and secure it within the
screen frame by pressing it underneath the retaining clips on the sides of the frame.
6. Replace the screen frame in the back of the front bezel.
7. Reinstall the front bezel onto the drive module.
Cleaning an Existing Air Filter
If replacement of an air filter is necessary and there is not a spare immediately available,
you can clean and reuse an existing filter using the following information:
1. Remove the front bezel and filter from the enclosure using the steps in “Removing
and Replacing the Filter” on page 41.
2. Immerse the air filter in a solution of warm water and mild detergent and rinse with
clean water.
3. Allow the air filter to dry completely before you reinstall it into the screen frame.
Caution: Placing a wet filter in the front bezel and installing it on the enclosure could
result in damage to the drive mechanisms or connectors in the enclosure.
!