User`s guide

58 007-4834-001
4: Replacing Enclosure Components
7. Review all documentation shipped with the new drive module for updated
replacement procedures and other information.
Caution: If the temperature of the shipping or storage environment differs
significantly from the temperature of the environment in which the drive module
will be installed, acclimate the drive module before you install it.
8. Slide the new drive module fully into the slot.
9. Lower (close) the lever.
10. Check to be sure that the drive activity indicators are on and that the fault indicators
above the new drive module are off.
Note: The fault indicator may flash intermittently while the drive spins up.
• If the activity indicator is off, the drive module may not be installed correctly.
Remove the drive module, wait 30 seconds, and then reinstall it.
• If the fault indicator stays on, or the activity indicator stays off, the new drive
may be bad. Use TPSSM to determine the problem.
11. Configure the new drive using TPSSM.
If you need to install more than one drive module, repeat the steps in this section.
!