Setup guide

36 007-5922-001
3: ISS3124-RP2 NAS Operation and GUI Startup
Tip: In most cases it is preferable to configure the appliance’s primary IP interface statically.
Follow your general local area network administration guidelines.
After you have reconfigured the Primary Network Interface, you should see an “Enabling
message” on the screen similar to:
Enabling ae0 via DHCP...OK.
After choosing your primary IP settings, you need to select no to the reconfigure prompt at the
bottom of the interface screen, see Figure 3-6.
Figure 3-6 Primary Network Interface Selection Screen Example
Choosing SGI NAS Web GUI Transport Protocols
After you have configured the primary network interface, you must choose a transport protocol
for the SGI ISS3124-RP2 NAS WEB GUI (NMV). You can select either HTTP – fast and (plain
text) unsecured, or HTTPS – secured, but less responsive.