User`s guide

Safety Summary -12
SAFETY SUMMARY
OG L
SAFETY PRECAUTIONS
■ Always keep the area around the printer tidy. Use the printer under the proper
lighting (500-1,000 lux.). Keep sufficient space around the printer so the hoppers
can be pulled forward. Space required in the vicinity of the printer is as follows:
Front side: 1 meters
Left, right and rear side: 1 meter
■ Do not place anything on the printer.
■ Do not open any covers during printing operation. It may cause personal injuries
if moving elements or electrical parts are accidentally touched.
■ Be particularly careful when working in the fuser unit area. Do not touch the
inside of the fuser unit. The fuser unit becomes very hot (approx. 374°F [190°C])
and it may cause personal injuries if accidentally touched.
■ Toner and developer are comprised of powdery particles. Avoid inhaling toner or
developer when it accidentally spills and circulates. If it spills on the floor,
immediately clean it with water-damped cloth. Do not leave it on the floor. It may
cause accidents if stepped on as they are slippery beads of metal.
■ Limit your operations to those described in this manual. Contact the field engineer
or service technician for further operations which are not explained in this
manual.
■ This equipment generates ozone. Long-term exposure should be limited to 0.1
ppm calculated as an 8 hr. time weighted average concentration. Provide proper
ventilation. Avoid installing the unit in a small room (smaller than 27cubic
meter). If installing in a space smaller than 27cubic meter, frequent ventilation is
necessary
0 2