Installation Instruction

Kupferfolie
Fax: [phone]
eMail: [e-mail]
Shadow Elektroakustik
Peter-Haendel Straße 2
91334 Hemhofen · Germany
Shadow Electronics of America Inc.
17791 Alexander Run
Jupiter, FL 33478 U.S.A.
Fax: +49 - 91 95 - 92 99 30
eMail: [e-mail]
Installation Instruction for Shadow SH 951
Single Side Upright Bass Pickup
Sensor
Fig. 1Fig. 1
Fig. 2Fig. 2
Content:Content:
Upright Bass Transducer with 1/4” socket,
Mounting adhesive,
Copper Foil Tape
Upright Bass Transducer with 1/4” socket,
Mounting adhesive,
Copper Foil Tape
Note:
Piezo pickups and transducers have a very high output impedance. In order to get the optimum sound output we recommend
an amplifier with low impedance input.
Note:
Piezo pickups and transducers have a very high output impedance. In order to get the optimum sound output we recommend
an amplifier with low impedance input.
3. Install the sensors into the bridge slots.
4. Locate the output socket in a convenient location on the instrument and attach with applied double sided adhesive.
5. Connect to appropriate amplifier with instrument cable.
3. Install the sensors into the bridge slots.
4. Locate the output socket in a convenient location on the instrument and attach with applied double sided adhesive.
5. Connect to appropriate amplifier with instrument cable.
1. Test fit sensors into the slot between the wing and foot.
Pickup should fit tightly for best output (see fig 1).
1. Test fit sensors into the slot between the wing and foot.
Pickup should fit tightly for best output (see fig 1).
2. If pickup is too loose, shim with included shim material (see fig 2 ). If pickup is too high, file the bridge slot slightly.2. If pickup is too loose, shim with included shim material (see fig 2 ). If pickup is too high, file the bridge slot slightly.