User's Manual

3
4.
Charging Status Indicator
LED indicator that gives off Red light, showing its charging
status: LED on---Compatible device is detected and charging
properly.
LED indicator shows green ---Charging complete.
5.
Features andNotes
FODinside
The metal foreign objects can be detected for a safer using experience.
Protection
No worries about over-heat, over-voltage, over-current or shut down.
Temperature & Effective Charging Distance Operating Temperature: -20-
60 Celsius degrees. Effective Charging Distance: 5 mm from TX coil to
RXcoil.
Remove items blocked between wireless charger and watch and keep effective
charging distance. Otherwise your watch will not be charged.
Do not put the metal interferences on the wireless charger.
If there is a foreign object between the wireless device and the wireless charging
base, the charger may not be able to charge normally.
Do not place too close to a card with a magnetic bar or chip (ID card and bank card
etc.) to avoid the card lose magnetism.
Please keep it away from fire and other chemical liquid.
Not toys for fun, please keep it away from children.
The charging equipment must meet the Qi standard to beuse.
6.
Warnings
Changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment. This equipment
has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
-- Reorient or relocate the receiving antenna.