User's Manual
Table Of Contents
- 1 Product introduction
- 2 Printer installation
- 3 Printer operation
- 3.1 Print head pressure and pressure position adju
- 3.2 Sensor position adjustment
- 3.3 Function of indicator light, button and LCD
- 3.4 Function of calibration
- 3.5 Print settings
- 3.6 Physical distance setting
- 3.7 Serial interface settings
- 3.8 Network Settings
- 3.9 Parallel interface settings
- 3.10 Date and time
- 3.11 Offline printing
- 3.12 Service
- 3.13 Consumables library
- 3.14 File operation
- 3.15 Printer debugging
- 3.16 Sensor settings
- 4 Routine maintenance
- 5 Troubleshooting
- Appendix
- Appendix 1 Technical specification
- Appendix 2 Self-test page
- Appendix 3 Print and paper output position
- Appendix 4 Communication interface
- Appendix 5 Guide for paper loading under peel-off
- Appendix 6 Guide for paper loading under label rew
- Appendix 7 Guide for paper loading under cutter mo
- Appendix 8 Menu on human-machine interface
- Appendix 9 FCC statement
BTP-7400 User’s Manual
- 13 -
3 Printer operation
Caution
The printer parameter settings are subject to the last settings. The printer
parameters can be set via the menu of printer operation interface, user
software (including drivers and the third-party software), printer commands,
etc. For example, the printer menu and the printer drivers in computer can
be used to set the print speed. Although the print speed has been set via
the printer menu, it will be updated to the speed set by the driver in the
computer after using the printer driver in computer to print.
3.1 Print head pressure and pressure position
adjustment
The print head pressure adjustment device is equipped with two
print head pressure adjustment knobs (8), and each knob can adjust
the print head pressure steplessly. Turn the knob leftward, the print
head pressure will increase (see Fig.3.1.1). The pressure position
lock knob (9) can adjust the pressure position and lock the pressure
size.