User's Manual
Table Of Contents
- 1 Product introduction
- 2 Printer installation
- 3 Printer operation
- 3.1 Print head pressure and pressure position adju
- 3.2 Sensor position adjustment
- 3.3 Function of indicator light, button and LCD
- 3.4 Function of calibration
- 3.5 Print settings
- 3.6 Physical distance setting
- 3.7 Serial interface settings
- 3.8 Network Settings
- 3.9 Parallel interface settings
- 3.10 Date and time
- 3.11 Offline printing
- 3.12 Service
- 3.13 Consumables library
- 3.14 File operation
- 3.15 Printer debugging
- 3.16 Sensor settings
- 4 Routine maintenance
- 5 Troubleshooting
- Appendix
- Appendix 1 Technical specification
- Appendix 2 Self-test page
- Appendix 3 Print and paper output position
- Appendix 4 Communication interface
- Appendix 5 Guide for paper loading under peel-off
- Appendix 6 Guide for paper loading under label rew
- Appendix 7 Guide for paper loading under cutter mo
- Appendix 8 Menu on human-machine interface
- Appendix 9 FCC statement
BTP-7400 User’s Manual
- 30 -
203DPI model is 832 dots, and the physical width of print head for
300DPI model is 1248 dots.
Caution
If the user software can also set the print width, the print width parameters
should be set in the user software.
3.5.5 Speed settings
1) Print speed
Set method: Menu → Settings → Print settings → Print speed (or
Menu →Common settings →Print speed). This method is used to
set the paper feeding speed during printing with a unit of
inch/second.
2) Paper feeding speed under idle status
Set method: Menu → Settings → Print settings →Paper feeding
speed under idle status. This method is used to set the paper
feeding speed under idle status (i.e. does not print) with a unit of
inch/second.
3) Paper retraction speed
Set method: Menu → Settings → Print settings →Paper retraction
speed. This method is used to set the print speed during paper
retraction (when the printer is set to rewinding mode, it has paper
retraction speed before printing) with a unit of inch/second.