User's Manual
Table Of Contents
- 1 Product introduction
- 2 Printer installation
- 3 Printer operation
- 3.1 Print head pressure and pressure position adju
- 3.2 Sensor position adjustment
- 3.3 Function of indicator light, button and LCD
- 3.4 Function of calibration
- 3.5 Print settings
- 3.6 Physical distance setting
- 3.7 Serial interface settings
- 3.8 Network Settings
- 3.9 Parallel interface settings
- 3.10 Date and time
- 3.11 Offline printing
- 3.12 Service
- 3.13 Consumables library
- 3.14 File operation
- 3.15 Printer debugging
- 3.16 Sensor settings
- 4 Routine maintenance
- 5 Troubleshooting
- Appendix
- Appendix 1 Technical specification
- Appendix 2 Self-test page
- Appendix 3 Print and paper output position
- Appendix 4 Communication interface
- Appendix 5 Guide for paper loading under peel-off
- Appendix 6 Guide for paper loading under label rew
- Appendix 7 Guide for paper loading under cutter mo
- Appendix 8 Menu on human-machine interface
- Appendix 9 FCC statement
BTP-7400 User’s Manual
- 44 -
3.9 Parallel interface settings
1) Parallel interface mode
Configure the mode of parallel interface. There are two modes can
be selected: byte mode and compatibility mode. When the user
needs to query the related parameters of printer from the host, the
byte mode should be selected. When the host does not need to
query the parameters of printer, the compatibility mode should be
selected.
2) Set ACK of Parallel interface
Configure the ACK of printer’s parallel interface. The user can select
to enable or disable the ACK. When the user host and the printer are
connected via some devices (such as partial USB-to-parallel, partial
print servers, etc.), the ACK needs to be enabled; when the printer
and the host are connected directly, the ACK can be disabled. The
disability of ACK can improve the data transfer rate to some extent.