User's Manual
Table Of Contents
- 1 Product introduction
- 2 Printer installation
- 3 Printer operation
- 3.1 Print head pressure and pressure position adju
- 3.2 Sensor position adjustment
- 3.3 Function of indicator light, button and LCD
- 3.4 Function of calibration
- 3.5 Print settings
- 3.6 Physical distance setting
- 3.7 Serial interface settings
- 3.8 Network Settings
- 3.9 Parallel interface settings
- 3.10 Date and time
- 3.11 Offline printing
- 3.12 Service
- 3.13 Consumables library
- 3.14 File operation
- 3.15 Printer debugging
- 3.16 Sensor settings
- 4 Routine maintenance
- 5 Troubleshooting
- Appendix
- Appendix 1 Technical specification
- Appendix 2 Self-test page
- Appendix 3 Print and paper output position
- Appendix 4 Communication interface
- Appendix 5 Guide for paper loading under peel-off
- Appendix 6 Guide for paper loading under label rew
- Appendix 7 Guide for paper loading under cutter mo
- Appendix 8 Menu on human-machine interface
- Appendix 9 FCC statement
BTP-7400 User’s Manual
- 76 -
Appendix 5 Guide for paper loading under peel-off
mode
When using label paper with adhesive, the user can set the paper
output mode to peel-off mode. When the peel-off mode is selected,
follow the steps below to wind the base paper on the rewinder
during paper loading:
1) Remove the front labels for about 1 meter long and ensure the
base paper is flat;
Appendix Fig. 5.1
2) Push the print head lifting up spanner backward to lift up the
print head module, and lead the base paper go through as the
route shown in the figure;
3) Push the print head lifting up spanner forward to press down