User's Manual

www.valortpms.com
3
INSTALLATION GUIDE – TEMPTRAC
Truck Diagram
Ther
e Are 2 Installation Steps For This Product:
2. TRUCK CAB INSTALLATION
NOTE: The Transceiver needs to be installed near
the GO7 Unit.
1.
Connect the s
upplied GO Wire Harness to the
Transceiver.
2.
Con
nect the other end of the supplied Valor
Wire Harness to the Geotab IOX-CAN Harness.
3.
The
Geotab IOX-CAN Harness connects to the
GO7 device. Connect to the vehicle where indicated.
4.
Data is commu
nicated over the Geotab IOX-CAN.
5.
Route the a
ntenna to the rear of the cab and mount in a
safe place away from step and pinch points.
Each zone transmits separately:

records ever 0.5 degree change

records temperature when power is turned on

records every 30 min when temperature is stable

exceptions for temperature threshold are set by vehicle in
MyGeotab
The Geotab Report can chart temperature
data in either Celcius or Farrenheit.
My Geotab Reporting
Valor + Geotab Setup
3. REEFER UNIT INSTALLATION
NOTE: Turn on Sensors prior to installation (back of unit). Sensors are active
once turned on. In humid environments or where sensor can get wet
after turning on sensor, use dialectic silicon,or sealant on sensor power
switch.
6.
The
re is a sensor for each zone and each sensor is assigned to a
zone. The sensor for zone one is marked
as such (Zone 1), while the sensor for zone two is unmarked.
Each sensor has a unique identifier code
which is pre-programmed into the Transceiver.
7.
Ins
tall the sensors directly onto the Reefer Zones’
inside wall or ceiling using either the supplied velcro or
with screws (not supplied).
8.
The
sensors wirelessly transmit data to the Transceiver.
ZONE 1 ZONE 2
Ante
nna
Sens
ors
Geot
ab
GO Device
Transceiver