User Manual

ManualsBrandsSHANGHAI BAOLONG AUTOMOTIVE ManualsAutomotiveTPMS SENSOR

Table Of Contents

OPERATION MANUAL OF TPMS SENSOR

M/N: QY1204AC1

Thank you for choosing our TPMS replacement sensor. It is for replacing TPMS sensor that

is already damaged or run out of battery.

PART ONE MOUNTING AND DISMOUNTING OF TRANSMITTER

1. Mounting of Transmitter

1.1 Identify Transmitter

Check whether the prepared sensor is the same with the image below. It is fixed angle

sensor.

Note: Only plastic or aluminum caps, aluminum valves and nickel plated valve cores can be

used when replaced.

1.2 Before the transmitter is installed, the rim around

the hole must be cleaned with a cloth.

Summary of content (4 pages)

PAGE 1
OPERATION MANUAL OF TPMS SENSOR M/N: QY1204AC1 Thank you for choosing our TPMS replacement sensor. It is for replacing TPMS sensor that is already damaged or run out of battery. PART ONE MOUNTING AND DISMOUNTING OF TRANSMITTER 1. Mounting of Transmitter 1.1 Identify Transmitter Check whether the prepared sensor is the same with the image below. It is fixed angle sensor. Note: Only plastic or aluminum caps, aluminum valves and nickel plated valve cores can be used when replaced. 1.
PAGE 2
1.3 Take off the nut ○5 , insert the valve stem through the rim hole from inside. 1.4 Place nut ○5 on the valve stem, and tighten with 5 Nm (44 inch pounds) torque. 1.5 Lock the rim on the tyre changer. (If the mounting head of the tyre changer is positioned at 12 o’clock, then the valve should be at the 7 o’clock position.) Apply lubricant on both the tyre bead and rim. Mount the lower tyre bead on the rim. Ensure that the tyre bead does not touch the electronic module during mounting. 1.
PAGE 3
2. Dismounting of Transmitter 2.1 Deflate the tyre and remove the wheel weights from the rim. Push the tyre bead away from the rim. Make sure to always set the bead breaker at least 90 degrees from the valve stem to avoid damaging the electronic module. 2.2 Firmly fix the wheel on the turntable clamps. (If the mounting head of the tyre changer is positioned at 12 o’clock, then the valves stem should be at the 11 o’clock position.
PAGE 4
communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: – Reorient or relocate the receiving antenna. – Increase the separation between the equipment and receiver.