User's Manual

INSTALLATION GUIDE
Mounting CV TPMS Sensor
Before installation, identify each pair of transmitter and ID module. There
are two labels coming with each pair of transmitter & ID module, and they
have the same ID code. For example: 01EB327F.
Install the transmitter onto the wheel and place the rim label on the rim.
Plug ID Module into Display (Refer to Operation of Display)
1. Loosen the steel strap. Wrap the strap around the centre of the rim in
the lowest spot and mark it 5 cm (2”) past worm gear. (Figure A)
2. Cut the extra strap. Install the tapered end of the strap through the
opening of the transmitter cradle. (Figure B)
3. Remove the adhesive tape liner from cradle and place transmitter
beside the tyre valve. Keep the strap parallel to the wheel flange and
ensure the strap is positioned in the lowest spot possible for correct
transmitter and cradle retention. (Figure C)
NOTE: The transmitter must be positioned in the lowest spot possible and
installed beside the tyre valve in order to know its approximate location
after the tyre has been mounted.
NOTE: When fixing the transmitter on the rim, make sure the section of
steel strap installed through the transmitter is complete, NOT TOOTHED.
(Figure D)
4. Position worm gear 10 cm (4”) away from the edge of the transmitter
and tighten worm gear until the transmitter cannot be moved. DO NOT
over tighten the strap, reference torque: 3-4 Nm (27-35 inch lbs.)
(Figure E)
5. Indicate the location and ID code of the transmitter by applying the
supplied rim label to a clean and dry location on the rim.
SHANGHAI BAOLONG AUTOMOTIVE CORPORATION
5500, Shenzhuan Rd., Songjiang, Shanghai 201619, China
Tel.: [phone] Fax: [phone]
E-mail: [e-mail]
Web: www.baolong.biz
A
D
C
B
E