User's Manual

DSL Gateway/Router — User Manual
Page 16 Total 24 Pages
Figure 3.19
3.5.1 WIRELESS BASIC SETUP
Click “Basic” on the left menu to setup basic wireless parameters. In default, check “Enable Wireless” box
to launch wireless AP.
l SSID (Service Set Identifier): The mobile users cannot access WLAN until setting their SSID as the same
value of the wireless ADSL. The SSID value of the ADSL is “wireless”
l Hide Access Point: If checked, wireless station will no see SSID of the ADSL.
3.5.2 WIRELESS SECURITY
Press “Security” on the left menu to construct wireless security. You can select to configure WEP
encryption, Shared, 802.1x, WPA, and WPA2 authentication.
l WEP Encryption
Select “Enabled” of the WEP encryption list. You can enter WEP encryption page.
Encryption Strength: Key length: 128bits or 64bits.
Network Key 1-4: Up to four keys that are in form of hex digitals could be set. Mobile users can’t
access the AP if they haven’t set the same key as AP. For 64bits and 128bits keys, you should input 10
and 26 hexadecimal digitals or 5 and 13 ASCII characters respectively. Every two digitals should be
comparted with others by a space character. For example: “7890ABCDEF” (hexadecimal digitals) or
“QWERT” (ASCII characters) for a key length of 64bits.