User's Manual

VDSL2 Modem User Manual
- 9 -
Figure 2.2
2.3.4 VDSL MODEM WORK MODE CONFIGURATION
1． For different protocols, the users need to set VDSL Modem accordingly as listed below:
Table 2.2
PPPoE
PPPoA
ATM VC
Protocol
Use DNS
User Name
Password
√
PPPoE
Enable
√
√
√
PPPoA
Enable
√
√
1483 Bridged
Lower interface
Default route
√
Disable
Note: √ means configure according to VDSL service provider’s instructed value.
PPPoE can also be realized via third party dialup software.
User Manual
Reference Chapter
PPPoE
PPPoA
1483 Bridged
3.3
3.3
3.2
2． After getting through every page for parameters set-up, click “Apply” to save the value in VDSL MODEM
3． Click the “Restore Default Settings” on “Management” Tab to enter the saving configuration page as
Figure 2.3. After the Modem reboot,The VDSL MODEM will work on the new parameters.