User's Manual

DB108-WL wireless ADSL MODEM manual
- 26 -
Please use the factory- recommended power supply.
Caution: To assure continued compliance, (example – use only shielded interface cables when
connecting to computer or peripheral devices). Any changes or modifications not expressly
approved by the party responsible for compliance could void the user’s authority to operate
the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications. However, there is
no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the interference by
one of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
- Consult the dealer or an experienced radio/TV technician for help.
RF Exposure
To comply with FCC RF exposure compliance requirements, the antenna used for this
transmitter must be installed to provide a separation distance of at least 20cm from all
persons and must not be co-located or operating in conjunction with any other antenna or
transmitter.
FCC INFORMATION: This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions (1). This device may not cause harmful interference, and (2) this
device must accept any interference received, including interference that may cause
undesired operation. Privacy of communications may not be ensured when using this
equipment.
FCC WARNING: This equipment generates or uses radio frequency anaroy. Changes or
modifications not expressly approved in writing may cause harmful interference and void the
user’s authority to operate this equipment.