User's Manual

DB108-WL wireless ADSL MODEM manual
- 5 -
Before the installation starts, please confirm information below or consult ADSL service provider. Table 2.1
shows all the information needed to configure according to different protocols.
Table 2.1
VIRTUAL DIAL
MODE
PRIVATE LINE MODE
PROTOCOL
PPPoE PPPoA 1483 BRIDGE
CONNECT
1483
ROUTING
1577 PRIVATE
LINE
VPI VPI VPI VPI LINE VPI
VCI VCI VCI VCI VCI
LLC/VCMUX LLC/VCMUX LLC/VCMUX LLC/VCMUX LLC/VCMUX
USER NAME USER NAME
IP ADDRESS/
MASK
IP ADDRESS/
MASK
NECESSARY
INFORMATION
PASSWORD PASSWORD GATEWAY GATEWAY
INSTALLATION
GUIDE
33 33
31
32 32
2.3.2 COMPUTER CONFIGURATION
The default factory-set IP Address for the ADSL MODEM is  192.168.1.1. The Subnet Mask is 
255.255.255.0Users can configure ADSL MODEM through an Internet browser. ADSL MODEM can be used as
gateway and DNS server; users need to set the computer’s TCP/IP protocol as follow:
1 Set the computer at same Internet segment with ADSL MODEMenter ADSL MODEM configuration
interface through a browser.
2 Set the computer’s gateway the same as the ADSL Modem’s IP address.
3 Set computer’s DNS server the same as the ADSL Modem’s IP address or that of an effective DNS server.
4. Wireless configurations are detail discussed in 2.3.5.
2.3.3 ADSL MODEM CONFIGUTATION
Open the browser; input http://192.168.1.1 at the address column. Press “Enter” key then the entry dialog box
will show up as Figure 2.1, Input username: admin, and password: dareadsl (Note that this is capital sensitive),
then the language selection page will appear. Please choose the “English” and click “OK”. The login pages are
shown as Figure 2.2.
(a) (b)
Figure 2.2
2.3.4 ADSL MODEM WORK MODEL CONFIGURATION
1 According to the different protocols, Users need to set ADSL Modem as listed below: