User's Manual

DB108-WL wireless ADSL MODEM manual
- 8 -
modem. The default SSID of modem is “default”
3 Channelto denote the different frequency of wireless signals whose value is from 1 to 11. The default value
is”6”. If there are more than one APs located in the same area, each of them must works at different channels to
reduce interference. For Example: Three APs are install in the same place, the channels should be 1,6 and 11
respectively.
4 Security: to enable or disable WEP Encryption mode.
Key length: 64 bits or 128 bits
Key1-4: up to four keys that are all in form of hex digitals could be set. Mobile users can’t access the AP if they
haven’t the same key as AP when WEP encryption mode is enabled.
5 After all parameters are finished setting, click the “submit” at the end of configuration page.
6 Then click “Save setting” to enter the “save configuration” page as Figure2.3 and click “Submit” button to
save the parameters. The modem will restart automatically with the new parameters.
2.3.6 DEFAULT CONFIGURATION
DB108-WL have pre-configuration the follow VCI/VPI
Table 1
VCI VPI
PVC 0 0 32
PVC 1 8 35
PVC 2 0 35
PVC 3 8 81
PVC 4 14 24
PVC 5 0 100
The default configuration is 1483 bridge LLC encapsulationIf you only use this modethere is no need to
configure. But if you want the routed modefor example PPPoEPPPoA1483routedthe other PVC must be
closed in advance.
Steps are as follow (close the PVC1) 
1 click“wan”select the “Per VC Setting” 1 on the right frame
2 click“Submit”.
3 Set the “enabled” item to “No” on the top as figure2.5.
4 click“Submit” again to activate the seeting.
5 Close the other PVCs similarly.
6
Click “Save Settings” in configuration item. Click “Submit” to save all the above settings. Then ADSL will
restart automatically and run under new parameters.