User's Manual

Regulatory Module Integration Instructions
2.2 List of applicable FCC rules
This device complies with part 15.247 of the FCC Rules.
2.3 Summarize the specific operational use conditions
This module can be applied in HID, sports and fitness sensors , health sensors,
mobile accessories as well as smart home. The input voltage to the module
should be nominally 1.8-3.6 V DC ，typical value 3V DC and the ambient
temperature of the module should not exceed 85℃.
This module using one kind of ceramic s antennas with maximum gain is 0
dBi ,the other kind of dipole antenna with maximum gain is 3dBi.Other
antenna arrangement is not covered by this certification.
If the antenna needs to be changed，the certification should be re-applied.
2.4 Limited module procedures
Not applicable
2.5 Trace antenna designs
Not applicable
2.6 RF exposure considerations
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment .This equipment should be installed and operated with
minimum distance 20cm between the radiator& your body. If the device built
into a host as a portable usage， the additional RF exposure evaluation may be
required as specified by 2.1093.
2.7 Antennas
Module contains one ceramics antenna or one dipole antenna.
2.8 Label and compliance information
The outside of final products that contains this module device must
display a label referring to the enclosed module. This exterior label can
use wording such as: "Contains Transmitter Module FCC ID: 2ACCRMC17
" ，or "Contains FCC ID: 2ACCRMC17 "，Any
similar wording that expresses
the same meaning may be used.
2.9 Information on test modes and additional testing requirements
a)The modular transmitter has been fully tested by the module grantee on the
required number of channels， modulation types， and modes， it should not
be necessary for the host installer to re-test all the available transmitter modes
or settings. It is recommended that the host product manufacturer， installing
the modular transmitter， perform some investigative measurements to confirm
that the resulting composite system does not exceed the spurious emissions