User's Manual

radiator circuitry is
enabled. Testing laboratories may need to add attenuation
or filters depending on the signal strength of any active beacons (if applicable)
from the enabled radio(s). See ANSI C63.4， ANSI C63.10 and ANSI C63.26 for
further general testing details.
The product under test is placed into a normal ‘paired' mode with another BLE
device
， as per the normal intended use of the product (for example，
transferring data).
FCC Statement
Any Changes or modifications not expressly approved by the party responsible
for compliance could void the user's authority to operate the equipment. This
device complies with part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference，
and (2) This device must accept any interference received ， including
interference that may cause undesired operatio.
ISED RSS Warning:
This device complies with Innovation, Science and Economic Development Canada
licence‐exempt RSS standard(s). Operation is subject to the following two conditions: (1) this
device may not cause interference, and (2) this device must accept any interference, including
interference that may cause undesired operation of the device.
Le présent appareil est conforme aux CNR d'ISED applicables aux appareils radio
exempts de licence. L'exploitation est autorisée aux deux conditions suivantes: (1) l'appareil ne
doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout
brouillage radioélectrique subi, même si le brouillage est susceptible d'en compromettre
le fonctionnement.
ISED RF exposure statement:
This equipment complies with ISED radiation exposure limits set forth for an uncontrolled
environment. This equipment should be installed and operated with minimum distance 20cm
between the radiator& your body.This transmitter must not be co‐located or operating in
conjunction with any other antenna or transmitter.
Le rayonnement de la classe b repecte ISED fixaient un environnement non
contrôlés.Installation et mise en œuvre de ce matériel devrait avec échangeur distance
minimale entre 20 cm tonon corps.Lanceurs ou ne peuvent pas coexister cette antenne ou
capteurs avec d’autres.
IC Label Instructions:
The outside of final products that contains this module device must display a label referring to
the enclosed module. This exterior label can use wording such as:
“Contains Transmitter Module
IC: 20625-MC17”,or “Contains IC: 20625-MC17”, Any similar wording that expresses the
same meaning may be used Instructions d'étiquetage IC:
L'extérieur des produits finis contenant ce module doit afficher une étiquette faisant référence
au module inclus. Cette étiquette extérieure peut utiliser des libellés tels que: contient le
module émetteur
IC: 20625-MC17 ”ou“ contient: IC: 20625-MC17 ”, tout libellé similaire exprimant le même
sens peut être utilisé
W
hen testing for emissions from the unintentional radiator
， the transmitter shall
be placed in the receive mode or idle mode， if possible. If receive mode only is
not possible then
， the radio shall be passive (preferred) and/or active scanning.
In these cases ， this would need to enable activity on the communication BUS
(i.e.， PCIe， SDIO， USB) to ensure the unintentional