User's Manual

Please note the setup must based on pair procedure well.
1. Turn the power switch on the transmitter & receiver to the ON position, the LED on transmitter & receiver
are continuously lit.
2. Move the steering wheel or throttle trigger to the position where you want the servo to move, press and hold
the receiver setup button for 2 second until the red LED on the receiver flash slowly, then press and hold the
receiver setup button again within 5 seconds (Note: after 5 seconds F/S setup will reset, you have to start over
at step one above) until the receiver LED is continuously lit, that's mean the F/S function has been correctly set.
3.Verify if the failsafe function has been correctly set. Turn off the transmitter, then check if the servos moves
to the position that you set.
4. Any new binding (pair procedure) will clear the preset Fail-Safe.