User's Manual

The receiver contains precision electronic parts. It is the most delicate radio

component on-board the model and should be protected from vibration,

shock and temperature extremes. To protect the receiver, wrap it in R/C foam

rubber or other vibration-absorbing material. If appropriate, waterproof the

receiver by placing it in a plastic bag and closing the open end with a rubber

band before wrapping it in foam. If moisture enters the receiver, intermittent

operation or a failure may result. Wrapping the receiver in a plastic bag also

protects it from fuel and exhaust residue which, in some models, can work its

way into the fuselage.

Transmitter antenna

1. The transmitter antenna is adjustable

so please make sure that the antenna is

never pointed directly at the model

when ﬂying as this creates a weak signal

for the receiver.

2. Keep the antenna perpendicular to the

transmitter's face to create a better RF

condition for the receiver. Of course

this depends on how you hold the

transmitter, but in most cases, adjusting

the transmitter antenna so that it is perpendicular to the face will give the

best results. Please adjust the transmitter antenna to the way you hold the

transmitter.

3. NEVER grip the antenna when ﬂying as this degrades RF quality.

Pair Procedure

The transmitter has a individual randomize ID that is created in the factory,

In order to start operation, the receiver must be linked with the ID code of

the transmitter with which it is being paired. Once the link is made, the ID

code is stored in the receiver and no further linking is necessary unless the

receiver is to be used with another transmitter. When you purchased another

R601FS, this procedure is necessary; otherwise the receiver will not work.

1. Place the transmitter and the receiver close to each other within 1 meter.

2. Turn on the transmitter then the receiver. If they are not paired, the receiver

red LED will blink per second or off, follow the next steps to link and pair

the receiver and the transmitter:

3. Press down the receiver "pair button" switch for more than two seconds,

once the receiver LED start to blink quickly, it shows they are paired,

release the switch.