User's Manual

The operating direction, neutral position, and steering angel of servo are adjustable.
Adjustments
Adjustment Procedure
Before making any adjustments, set all the
SERVO REVERSER switches on the side of
the transmitter to the lower (NOR) position.
(Switch the switches with a small screwdriver,
etc.)
Turn on the transmitter and receiver power
switch and make the following adjustments:
1. Check the direction of
operation of the servo.
If a servo operates in the wrong direction,switch
its SERVO REVERSER switch.(The direction
of operation can be changed without changing
the linkage.)
2. Check the engine throttle
(speed adjustment) linkage.
Change the servo horn installation position
and hole position so that the throttle is opened
fully when the throttle stigger is set to HIGH
(back ward) and is closed fully when release
the throttle stigger
.
.
.
.
3. After all the linkages have
been connected, recheck the
operating direction, throw,
etc.
Before running adjust the car in accordance
with the kit and engine instruction manuals.
4. Run the car and trim the
servo.
RR
8