User's Manual

FCC Caution:
(1)Exposure to Radio Frequency Radiation. This equipment
must be installed and operated in accordance with provided
instructions and the antenna(s) used for this transmitter must be
installed to provide a separation distance of at least 20 cm from
all persons and must not be collocated or operating in
conjunction with any other antenna or transmitter. End-users
and installers must be provided with antenna installation
instructions and transmitter operating conditions for satisfying
RF exposure compliance.
(2) Any changes or modifications not expressly approved by the
grantee of this device could void the user's authority to operate
the equipment.
(3) This Transmitter must not be co-located or operating in
conjunction with any other antenna or transmitter.
(4) Labelling requirements:This device complies with part 15
of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference,
and (2) this device must accept any interference received,
including interference that may cause undesired operation.
(5) if the host is marketed so that end users do not have straight
forward commonly used methods for access to remove the
module so that the FCC ID of the module is visible; then an
additional permanent label referring to the enclosed module:
Contains Transmitter Module FCC ID: 2AK9D-L710or
Contains FCC ID: 2AK9D-L710 must be used.
This Modular Approval is limited to OEM installation for mobile
and fixed applications only. The antenna installation and
operating configurations of this Modular, including any
applicable source-based timeaveraging duty factor, antenna gain
and cable loss must satisfy MPE categorical Exclusion
Requirements of 2.1091.