Data Sheet
Table Of Contents
- Abstract
- 1. Introduction
- 2. Characteristic
- 3. Pin Definition
- 4. System memory space
- 5. ATE（RF Test Mode）
- 5.1. ATE Command
- 5.1.1. Start MP mode
- 5.1.2. Stop MP mode
- 5.1.3. Set Tx rate
- 5.1.4. Set operational channel
- 5.1.5. Set operational bandwidth
- 5.1.6. Set Tx power
- 5.1.7. Set antenna for Tx
- 5.1.8. Set antenna for Rx
- 5.1.9. Start air Rx mode
- 5.1.10. Start continuous Tx mode
- 5.1.11. Query air Rx statistics
- 5.1.12. Reset air Tx/Rx statistics
- 5.2. Example Command
- 5.1. ATE Command
- 6. Flash Programing
- 7. Electrical parameters
- 8. Antenna Information
- 9. Assembly size and PCB package
- 10. Production Guidelines
- 11. FCC and IC Information
- 11.1. FCC Warning
- 11.2. IC warning
- 11.3. Trace antenna designs
- 11.4. RF exposure considerations
- 11.5. Antennas
- 11.6. Label and compliance information
- 11.7. Information on test modes and additional testing requirements5
- 11.8. Additional testing, Part 15 Subpart B disclaimer
- 11.9. The module is limited to OEM installation ONLY.
- 11.10. The OEM integrator is responsible for ensuring that the end-user has no manual instructions to remove or install module.
- 11.11. The module is limited to installation in mobile or fixed applications
- 12. Package and Label
- Appendix 1: Sales and Technical Support Information
EMC328x Series Wireless Module Data Manual
Copyright of Shanghai MXCHIP Information Technology Co., Ltd.
4
▪ HS-GDMA0 Support 6 channels and support TrustZone-M technology
▪ LP -GDMA0 supports 6 channels
⚫ Flash
▪ SPI Flash controller with Cache
▪ Support ICP technology and program Flash directly
⚫ General-Purpose I/O (GPIO)
▪ 16 GPIOs with upper and lower pull-down resistors
▪ Configurable external interrupt triggered by rising edge, falling edge and double edge
Wireless Communication
⚫ Wi-Fi
▪ 802.11 b/g/n 1x1, 2.4GHz
▪ Support 20MHz/40MHz bandwidth, 802.11n rate reaches MCS7
▪ Low-power architecture, low-power transceiver for short-range applications, low-power beacon
listening mode, low-power RX mode, low-power suspend mode (DLPS)
▪ Support external amplifier
⚫ BT BLE
▪ Support low-power Bluetooth
▪ Support both master and slave modes
▪ High power mode (10dBm, sharing PA with Wi-Fi)
▪ Built-in Wi-Fi/Bluetooth single antenna coexistence mechanism
Safety
▪ AES/DES/SHA hardware encryption algorithm engine
▪ Support TrustZone-M technology
▪ Secure boot secure boot
▪ SWD debug interface protection to prevent the debug interface from accessing protected and
forbidden areas
▪ Support RSIP, automatic decryption of Flash data
Communication interface
⚫ USB
▪ Support USB 2.0, high speed / full speed / low speed mode
▪ Support DMA transfer, 1.5Kbyte input block buffer, 1.5Kbyte output block buffer