User's Manual

65
1. Make sure your remote control is in range of the Gateway. Remove the battery cover
from the back of the remote control so that you have access to the Program button.
2. On the Gateway, press the sync button once. The activity indicator begins to display
a clockwise rotating pattern.
3. On the remote control, press and hold the Program button.
4. While pressing the Program button, press the 1-4 button three times consecutively.
5. Release the Program button. The primary indicator light on the remote control flashes while the remote
control connects with the Gateway. When this process is complete, the indicator light will remain on for
approximately five seconds. When the indicator light turns off, your remote control is connected to the
Gateway.
6. Press the sync button on the Gateway again to stop the network search process (otherwise the
Gateway will stop the search process automatically in two and a half minutes).
Note: The remote control loses the ability to add bulbs to the lighting network, delete light bulbs from the lighting network, and
clone a remote control once it joins the lighting Gateway.
Turning Lights On and Off
To turn lights on and off, you must turn on and off an entire lighting group: