User's Manual

Remote Control Indicators
The remote control has four group number indicator lights and one primary status indicator light that display the
following patterns to show you the remote control’s status during different processes:
Process
Indicator and Description
Initial Remote Control
Setup
Primary indicator flashes steadily: During the process of installing batteries for the first time, the
remote control is determining the best signal for your lighting system.
Adding Light Bulbs to
Network
Group number indicator flashes steadily:
The corresponding lighting group is the active group for the
new light bulbs to join.
Primary indicator flashes rapidly: The remote control has found a new light bulb within range. After
the light bulb is successfully added to the network, the indicator stops flashing.
Primary indicator turns on solid: The light bulb has been successfully added to the network.
Removing Light Bulbs
from Network
Group number indicator and primary indicator flash slowly for 30 seconds: One or more light
bulbs have been removed.
Working with One
Lighting Group
Group number indicator turns on, and primary indicator remains off: The corresponding lighting
group has been selected, and its last state was off.
Group number indicator and primary indicator turn on: The corresponding lighting group has been
selected, and its last state was something other than off (for example, lighting group was on or was
dimmed to a certain level).
Working with All
Lighting Groups
All group number indicators turn on, and primary indicator remains off: All lighting groups have
been selected, and their last state was off.
All group number indicators and primary indicator turn on: All lighting groups have been selected,
and their last state was something other than off (for example, lighting groups were on or were dimmed
to a certain level).
Cloning the Remote
Control
Primary indicator flashes steadily: The remote control is in cloning mode.
Primary indicator flashes rapidly: The remote controls are transferring data between each other.
Primary indicator turns on solid: Both remote controls have finished the cloning process successfully.
Group number indicators flash steadily for 2 seconds: The cloning process timed out or failed.