User's Manual

1. Reset Existing Network Light Bulbs, if Any
If you are not upgrading from a remote control lighting kit, you can skip this step. If you are upgrading
from a remote control lighting kit, then you must reset all light bulbs that you previously installed as part of that
kit’s setup. The easiest way to reset all light bulbs is to do so through the original remote control (the remote
control that came with the kit you are upgrading):
Note: If the original remote control is not available, you can reset the original light bulbs manually. To do so, refer to the
Remote Control chapter.
1. Make sure power to the fixtures containing the light bulbs you want to reset is turned ON.
2. Remove the battery cover from the back of the original remote control so that you have access to the
Program button.
3. On the remote control:
a. Press and hold the Program button.
b. While pressing the Program button, press and release the On/Off button (keep the Program
button pressed).
c. While still pressing the Program button, press and release the 1-4 button.
d. While still pressing the Program button, press and release the On/Off button again.
e. Release the Program button. All group number indicator lights and the primary indicator light
flash slowly for 30 seconds while the light bulbs are removed.