User's Manual

Mounting the Gateway on a Wall
You can mount the Gateway to a wall with screws, using the mounting slots located on the back of the Gateway.
As shown in the illustration, you should use two self-tapping screws for mounting with the following dimensions
(also refer to the corresponding illustration callouts):
1. 5.3 mm
2. 15 mm
3. M3
Screw the self-tapping screws into the wall, level with a
distance of 60 mm between the center point of the two
screw heads. Hang the Gateway by sliding the holes
on the back of the unit over the screws and then gently
pressing the Gateway downward until it is secure.