User's Manual

Note: If you are installing a new light bulb that did not come with your kit (for example, if you reset network light bulbs from a
remote control kit), then you must manually connect the light wirelessly to your Gateway. In this case, you should be ready to
access your Gateway during the steps below as you will have to press its sync button to engage the network connection.
Before installing the light bulbs, determine the appropriate locations in your home for installing them. The
Lighting Kit Overview chapter provides information on planning your lighting network. When you are ready to
install the light bulbs, perform the following steps:
1. Turn power OFF to the light fixtures where you will be installing the network light bulbs.
2. Remove any existing standard light bulbs from the light fixtures.
3. Install each network light bulb into the light fixtures as you would any standard light bulb.
4. Turn power on to the light fixtures.
5. If you are installing only light bulbs that came with your kit, you can skip this step. However, if you
are also installing light bulbs that did not come with your kit (for example, if you reset network light
bulbs from a remote control kit), then you must connect them to your Gateway:
a. When you turn power on, the light bulbs will brighten and dim while attempting to connect
wirelessly to your Gateway.
b. Press the sync button on the Gateway once to enable the connection. The
activity indicator begins to display a clockwise rotating pattern.
c. When the light bulbs are connected to your Gateway, they turn on to full
brightness. Press the sync button on the Gateway again to stop the network
search process (otherwise the Gateway will stop the search process
automatically in five minutes after finding the most recent light bulb).