User's Manual

Once this process is complete, you can use the remote control as discussed in the rest of this chapter.
Connecting a New or Pre-existing Remote Control to the Gateway
The remote control in your lighting kit is already connected to your Gateway by default, so it is ready to use after
you prepare it as discussed above. However, there are a few situations in which you would have to manually
connect a remote control to your Gateway:
• If you are adding a new remote control to your network
• If you are upgrading your lighting network from a remote control kit and would like to use the old
remote control with your new network
• If you performed a factory reset on your remote control and need to re-connect it to the Gateway
To physically connect a new or pre-existing remote control to the Gateway:
1. Make sure your remote control is in range of the Gateway. Remove the battery cover
from the back of the remote control so that you have access to the Program button.
2. On the Gateway, press the sync button once. The activity indicator begins to display
a clockwise rotating pattern.
3. On the remote control, press and hold the Program button.
4. While pressing the Program button, press the 1-4 button three times consecutively.
5. Release the Program button. The primary indicator light on the remote control flashes while the remote
control connects with the Gateway. When this process is complete, the indicator light will remain on for