User's Manual

Replacing Batteries
Your remote control uses two AA 1.5V alkaline batteries (included). To replace the batteries, remove the battery
cover from the back of the remote control and remove the old batteries. Insert the new batteries as indicated in
the battery compartment.
CAUTION: RISK OF EXPLOSION IF BATTERY IS REPLACED BY AN INCORRECT TYPE.
DISPOSE OF USED BATTERIES ACCORDING TO THE INSTRUCTIONS.
Resetting the Remote Control
You can reset the remote control back to the original default settings from the factory. This may be useful if you
want to put a cloned remote control back to its standalone settings. Typically, though, factory reset is not a
common procedure and you should be certain you want to do so since you will lose any network settings you
previously programmed onto the remote control.
If you are sure you want to reset the remote control, use the following steps:
1. Remove the battery cover from the back of the remote control.
2. Remove the batteries from the remote control.
3. Press and hold the Program button.
4. While still pressing the Program button, reinsert the batteries into the remote control.
5. Release the Program button.