User's Manual

Troubleshooting
If you are having problems with your lighting system, refer to the following sections for possible troubleshooting
solutions.
Light Bulb Not Responding During Installation
When you add a new light bulb to the network (or if you add a previously existing light bulb that you removed
from the network), the light bulb should brighten and dim during the installation process to indicate that it is
searching for a network. If for any reason the light bulb does not brighten and dim (if it remains full bright), then
turn power to the light fixture off and on four times consecutively to reset the light bulb. The light bulb should then
start to brighten and dim once it is reset, which is usually within 10 seconds after the fourth off/on cycle.
Light Bulb Accidentally Removed from Network
It is possible for a network light bulb to be accidentally removed from the network. For example, if someone turns
power off and on four times consecutively to the light fixture, the attached light bulb will reset and remove itself