User's Manual

from the network. If this happens, follow the procedure in the Light Bulb Tasks chapter to add a new light bulb to
the network.
Resetting Your Light Bulbs
If you are unable to fix issues that arise with your lighting system, you can reset your light bulbs as a last resort.
To do so, follow the procedure in the Light Bulb Tasks chapter to remove light bulbs from the network, followed
by the procedure to add a new light bulb to the network.
Problems with Remote Control
Depending on the problem you are having with the remote control, there are several possible solutions:
• Replace batteries. If the remote control is not functioning and the indicator lights do not light when
you press the buttons, then the batteries may need replacement. Refer to the Remote Control
Operation chapter for instructions on inserting new batteries into the remote control.
• Turn power to light fixture on. If you manually turn the power switch off for a light fixture, then
power will not be available to the light bulb when you use the remote control to turn the light on and
off. Be sure the appropriate light fixtures are left in the on position. If necessary, refer to the section
on power failure in the Lighting Kit Overview chapter.
• Place remote control at an adequate distance from light bulb. Not only must you ensure the
remote control is within range of the nearest network light bulb, you must also ensure it is not too
close. Operating the remote control too close to a network light bulb could interfere with the remote