User's Manual

installation
Installation of your lighting kit includes installing the light bulbs
into light fixtures and preparing the remote control.
INSTALLATION STEPS
Before installing the light bulbs, determine the appropriate
locations in your home for installing them. The Lighting Kit
Overview chapter provides information on planning your lighting
network. When you are ready to install the light bulbs, perform the
following steps:
01. Turn power OFF to the light fixtures where you will be
installing the network light bulbs.
02. Remove any existing light bulbs from the light fixtures.
03. Install each network light bulb into the light fixtures as you
would any standard light bulb.
04. Turn power on to the light fixtures. The light bulbs turn on to
full brightness. If a light fixture has a dimmer control (not
recommended), set the dimmer level to full brightness.
05.Remove the battery compartment cover from the back of
the remote control, and insert two AA alkaline batteries
(included). The first time you insert batteries, the primary
indicator light flashes while the remote control determines
the best signal for your lighting system. When this
process is complete, the indicator light will remain on for
approximately five seconds. When the indicator light turns
off, your remote control is ready.
12