User's Manual

Note: The previously selected group (or all groups, if selected) remains the active
group on the remote control. To take action on that same group again, you do not have
to press the group button again.
Changing a Light Bulb’s Lighting Group
To change a light bulb’s lighting group, you must first remove the
bulb from the network using the removal procedure in the Light
Bulb Tasks chapter. After the light bulb is removed, you can use the
procedure in that same chapter for adding the light bulb to the
network and assign it to the new lighting group.
Cloning a Remote Control
If you have an additional remote control, you can program it to be
identical to your original remote control. This is useful if you think
you may need to replace your original remote control or if you sim-
ply want to have a backup. When you clone an additional remote
control, it will work the same way as your original remote control.
Before you get started, make sure you have your original remote
control in addition to your new one. Both remote controls must be
in range of each other. Remove the battery covers from both remote
controls so you have access to the Program buttons. To clone the
new remote control:
16