User's Manual

Replacing Batteries

Your remote control uses two AA 1.5V alkaline batteries (includ-

ed). To replace the batteries, remove the battery cover from the

back of the remote control and remove the old batteries. Insert the

new batteries as indicated in the battery compartment.

CAUTION: RISK OF EXPLOSION IF BATTERY IS

REPLACED BY AN INCORRECT TYPE. DISPOSE OF USED

BATTERIES ACCORDING TO THE INSTRUCTIONS.

Resetting the Remote Control

You can reset the remote control back to the original default

settings from the factory. This may be useful if you want to put a

cloned remote control back to its standalone settings. Typically,

though, factory reset is not a common procedure and you should

be certain you want to do so since you will lose any network

settings you previously programmed onto the remote control. If

you have light bulbs programmed on the remote control then

it is better to remove them from the network ﬁrst since you will

lose control of any light bulbs conﬁgured to work with the remote

control. Refer to the Light Bulb Tasks chapter for instructions on

removing a light bulb from the network.