User's Manual

If you are sure you want to reset the remote control, use the
following steps:
01. Remove the battery cover from the back of the remote.
02. Remove the batteries from the remote control.
03. Press and hold the Program button.
04. While still pressing the Program button, reinsert the
batteries into the remote control.
05. Release the Program button.
The remote control is returned to its default factory settings. To
use it again, you must follow the original installation instructions.
After the factory reset, you must reset all light bulbs in the network
based on your group plan by following the procedure in the Light
Bulb Tasks chapter to remove light bulbs from the network, fol-
lowed by the procedure to add a new light bulb to the network.
light bulb tasks
There are additional network tasks that you may find you must
perform with your light bulbs, including:
• Adding light bulbs to your network
• Removing light bulbs from the network
Adding Light Bulbs to the Network
When you add a light bulb to the network, you also assign it to a
lighting group. To add light bulbs to the network:
19