User's Manual

01. Make sure your remote control is in range of the light bulb
you are adding. Remove the battery cover from the back of
the remote control so that you have access to the Program
button.
02. Make sure power to the fixture where you are installing the
light bulb is turned OFF.
03. Remove any existing light bulb from the light fixture.
04. Install the network light bulb into the light fixture as you
would any standard light bulb. If the light fixture has a dim-
mer control (not recommended), set the dimmer level to
full brightness.
05. Turn power to the light fixture on. The light bulb begins to
brighten and dim while searching for the remote control’s
network.
Note: If for any reason the light bulb does not brighten and dim (if it remains full
bright), then turn power to the light fixture off and on four times consecutively to
reset the light bulb. During this process, only leave the power off or on for less than
two seconds. The light bulb should then start to brighten and dim.
06. On the remote control, press and hold the desired lighting
group button for three seconds. When the light bulb is
found and is being configured by the remote control, the re-
mote control’s primary indicator light flashes rapidly. When
the light bulb has been successfully added to the network,
it will turn on at full brightness and the remote control’s
primary indicator will turn on solid. The group number
20