User's Manual

indicator light on the remote control will continue to flash for
up to five minutes to give you time to install any additional
light bulbs to that lighting group.
07. To add more light bulbs, repeat these steps. Remember, if
the group number indicator light on the remote control is
still flashing from step 6, then it will automatically find the
new light bulb without you pressing any buttons, and it will
add the bulb to the same lighting group. However, if the indi-
cator light has stopped flashing, then you must repeat step
6. Repeat this for each additional light bulb you are adding.
08. When you are finished adding all new light bulbs, you can
return the remote control back to normal operation by
pressing the Program button. Otherwise the remote control
will automatically return to normal operation in five minutes.
Both the primary indicator light and the group number
indicator light turn off when the remote control returns to
normal operation.
09. Leave the light fixture switches ON so that power is
available when using your remote control to turn the light
bulbs on and off.
Removing Light Bulbs from the Network
When you remove a light bulb from the network, you remove all
of its network settings. If you are removing light bulbs assigned to
different lighting groups, you must work with one lighting group at
a time. However, if you are removing light bulbs from ALL lighting
groups, you can remove them all at the same time. To remove light
bulbs from the network:
21