User's Manual

to turn the light on and off. Be sure the appropriate light
fixtures are left in the on position. If necessary, refer to the
section on power failure in the Lighting Kit Overview chapter.
• Place remote control at an adequate distance from light
bulb. Not only must you ensure the remote control is within
range of the nearest network light bulb, you must also ensure
it is not too close. Operating the remote control too close to
a network light bulb could interfere with the remote control’s
signal. You should hold the remote control at least 1 foot (.3
meters) away from any of your network light bulbs.
• Reset the remote control. If the remote control is not
functioning correctly but the batteries are new, then you may
have to reset the remote control to its default factory settings.
The factory reset process is as discussed in the Remote
Control Operation chapter.
• Replace a lost or broken remote control. If you have an
additional remote control that was previously programmed
to be identical to the your original remote control (cloning
your original remote control, as discussed in the Remote
Control Operation chapter), then you can use that clone the
same way as your original without losing any of your network
or light settings. However, if you do not have an additional
identical remote control, then there is no way to retrieve
your settings from the lost or broken remote control. The only
option in this case is to reset your entire lighting system, as
discussed earlier in this chapter.
27