Operation Manual

Press “Cancel” and return to its Previous Menu.
13.3 SRAM test
Select 3．SRAM TEST and press “Enter” to begin to test, and it will display as follows:
04/03/16 13:24 04/03/16 13:24
SRAM TEST SRAM test
CHECK APP．．． Check application…
MEMORY TEST OK！ Memory test OK!
Note! :
The first time take SRAM test system would prompt the test failed, if is displays “MEMORY TEST
OK！”during any of the following test, it means that the machine works normal. If the system has
downloaded the application program, this function shall not be tested, it is the normal to display
“ERR：CANNOT DO TEST！”.
13.4 Flash test
Select 4．FLASH TEST 按 and press “Enter” to begin to test, and display as follows:
04/03/16 13:24 04/03/16 13:24
FLASH TEST Flash memory test
Please Select Flash： Please select flash that needs to be tested:
1
Flash Write Test OK！ Flash write test OK!
Since there may be several flashed, we can check them one by one by inputting their correspondent
No, like above table, input “1” to check the first flash in the machine.
Note! :
Have enough knowledge of the configuration of the machine before flash test. Input the No. of flash
memory, if its correspondet flash does not exist, system will display “ERR：WRITE FLASH”.
Notice there should be no abnormal phenomona like: falsh write test failed, No. location does not
accord with flash, system halted or resetting etc.
14 Battery test
Select 1．BATTERY in page 3 and press “Enter” to begin to test, it displays as follows:
04/03/16 13:24 04/03/16 13:24
BATTERY 1 Battery test 1
1．POWER DETECT Power detect
2．POWER OFF TEST Power off test
14.1 Power detect
Select 1．POWER DETECT in the condition that external power is on, press “Enter” to begin to test,
it displaysas follows:
04/03/16 13:24 04/03/16 13:24
POWER IS ON Power is on
PRESS KEY TO CONTINUE Press any key to continue.
Select 1．POWER DETECT in the condition that the external power is off, press “Enter” to begin to
test, it displays as follows: